which cisco ios switch command is used to configure the use of lacp on an interface?

That is, the remote side transmits link aggregationĬontrol PDUs at the specified interval. It is the configuration on the local side that specifies the behavior The periodic statement on the interfaces on the local side. Side of the link transmit link aggregation control PDUs by configuring You configure the interval at which the interfaces on the remote Passive interfaces at different rates, the transmitter honors the You can configure different periodic rates When they receive them from the remote end of the same link.īy default, the actor and partner transmit link aggregationĬontrol PDUs every second. Transmission mode, links send out link aggregation control PDUs only Passive mode, they do not exchange link aggregation control PDUs.Īs a result, the aggregated Ethernet links do not come up. Passive mode-If the actor and partner are both in The actor knows about its own state and that of the partner’s The actor sends linkĪggregation control PDUs to its protocol partner that convey what They exchange link aggregation control PDUs. The transmission of link aggregation control protocol data units (PDUs)Īnd response link aggregation control PDUs, you must enable LACP atīoth the local and remote ends of the links, and one end must be active:Īctive mode-If either the actor or partner is active, Setting the mode to either passive or active. LACP is enabled on an aggregated Ethernet interface by The remote end of the link is known as the partner.

Within LACP, the local end of a child link is known as the actor and Means for exchanging information between partner systems on a link. Link Aggregation Control Protocol (LACP) provides a standardized

Which cisco ios switch command is used to configure the use of lacp on an interface?